Lancer L4-2.4L (4B12) (2009)
1. Remove the sealant and grease on the top surface of cylinder block and on the bottom surface of the cylinder head. Then, use the white gasoline or
the like to degrease the sealant application surface.
2. Apply the sealant to the top surface of cylinder block as shown in the figure.
Specified sealant: Three bond 1217G
3. Within three minutes after the sealant application, install the cylinder head gasket to the cylinder block.
NOTE: When the cylinder gasket is installed to the cylinder block, check that the sealant is securely applied to the bead line of the cylinder head
gasket.
4. Apply the sealant to the top surface of cylinder head gasket as shown in the figure.
Specified sealant: Three bond 1217G
CAUTION
After the installation, until a sufficient period of time (one hour or more) elapses, do not apply the oil or water to the sealant application area
or start the engine.