Lancer L4-2.4L (4B12) (2009)
/Page-413006.png)
1. Check that the sprocket timing chain mating marks align with the link plates (orange or blue) of the timing chain, and install the timing chain
tensioner to the cylinder block.
2. Remove the hard wire or L-shaped hexagon wrench fixing the plunger of the timing chain tensioner to apply tension to the timing chain.
]]C[[ CRANKSHAFT FRONT OIL SEAL INSTALLATION
1. Apply a small amount of engine oil to the entire inner diameter of the crankshaft front oil seal lip.
CAUTION
When installing the crankshaft front oil seal, be careful to avoid damage to the crankshaft front oil seal.
2. Using special tool MB991448, press in the crankshaft front oil seal up to the chamfered surface of timing chain case.
]]D[[ TIMING CHAIN CASE ASSEMBLY INSTALLATION
CAUTION
^
Be sure to remove the sealant remaining in the mounting hole, O-ring groove, and gap between parts.
