Lancer L4-2.4L (4B12) (2009)
OK: Continuity exists (2 ohms or less)
3. Check the wiring harness between joint connector (CAN1) C-06 (terminal 16) and WCM connector C-09 (terminal 10)
OK: Continuity exists (2 ohms or less)
Q: Is the wiring harness between joint connector (CAN1) C-06 and WCM connector C-07 in good condition?
YES : Check the power supply circuit of the WCM. Refer to Diagnosis. See: Body and Frame/Body Control Systems/Testing and
Inspection/Symptom Related Diagnostic Procedures/Trouble Symptom Chart
NO : Repair the wiring harness between joint connector (CAN1) C-06 and WCM connector C-07.
Diagnostic Item 18
DIAGNOSTIC ITEM 18: Diagnose when the scan tool cannot receive the data sent by SRS-ECU.
CAUTION: When servicing a CAN bus line, ground yourself by touching a metal object such as an unpainted water pipe. If you fail to do so, a
component connected to the CAN bus line may be damaged.