Lancer L4-2.4L (4B12) (2009)
2. Measure the resistance between ETACS-ECU connector terminal 6 and body ground.
OK: 1 kilo ohm or more
3. Measure the resistance between ETACS-ECU connector terminal 7 and body ground.
OK: 1 kilo ohm or more
Q: Do all the resistances measure 1 kilo ohm or more?
YES : Go to Step 2.
NO : Go to Step 13.
STEP 2. Check the wiring harness between joint connector (CAN1) C-06 and combination meter connector C-04 for a short to ground.
Measure the resistance at joint connector (CAN1) C-06.
1. Disconnect joint connector (CAN1), and measure the resistance at the wiring harness side of joint connector (CAN1).
2. Measure the resistance between joint connector (CAN1) terminal 3 and body ground.
OK: 1 kilo ohm or more