Lancer L4-2.4L (4B12) (2009)
/Page-627174.png)
4. Measure the voltage between joint connector (CAN1) terminal 13 and body ground.
OK: 4.7 volts or less
Q: Do all the voltages measure 4.7 volts or less?
YES : Go to Step 24.
NO : Go to Step 57.
STEP 24. Check the wiring harness between joint connector (CAN1) C-06 and ETACS-ECU connector C-301 for a short to power supply.
Measure the voltage at joint connector (CAN1) C-06.
1. Disconnect joint connector (CAN1), and measure the voltage at the wiring harness side of joint connector (CAN1).
2. Turn the ignition switch to the ON position.
3. Measure the voltage between joint connector (CAN1) terminal 6 and body ground.
OK: 4.7 volts or less
4. Measure the voltage between joint connector (CAN1) terminal 19 and body ground.
OK: 4.7 volts or less
Q: Do all the voltages measure 4.7 volts or less?
YES : Go to Step 58.
NO : Repair the wiring harness between joint connector (CAN1) C-06 and ETACS-ECU connector C-301.
