mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Procedures|Page 5031 > < Procedures|Page 5029
Page 3
background image

3. Does the "SRS" warning light illuminate for approximately seven seconds, and then go out?
4. If yes, the SRS system is functioning properly. If not, consult Diagnostic Trouble Code Chart [SRS-ECU].

Side Impact Sensor

SIDE IMPACT SENSOR

REMOVAL AND INSTALLATION

WARNING:

-

Never attempt to disassemble or repair the side impact sensor. If faulty, replace it.

-

Do not drop or subject the side impact sensor to impact or vibration. Replace the side impact sensor, if dents, cracking, deformation, or
rust are present.

-

Replace the side impact sensor after the side and curtain air bag has deployed.

Pre-removal Operation

Removal Steps 1-3

NOTE:  The illustration above shows the side impact sensor (LH). The position of the side impact sensor (RH) is symmetrical to this.

REMOVAL SERVICE POINTS

[A] NEGATIVE (-) BATTERY CABLE DISCONNECTION

Procedures|Page 5031 > < Procedures|Page 5029