Lancer L4-2.4L (4B12) (2009)
/Page-1169003.png)
1. Install special tool MB991897 or MB992011 as shown in the figure.
2. Turn the bolt and knob to make the special tool jaws parallel, then hand-tighten the bolt. After tightening, check that the jaws are still parallel.
NOTE: To adjust the special tool jaws to be parallel, set the orientation of the knob as shown in the figure.
3. Unscrew the bolt to disconnect the ball joint.
[[B]] FRONT AXLE CROSSMEMBER REMOVAL
1. Jack up and support the crossmember, and remove it.
2. Check the hoses and harnesses for roughness, and then remove the front suspension crossmember with the rear roll stopper and the steering gear
and linkage installed.
INSTALLATION SERVICE POINT
]]A[[ JOINT COVER GROMMET INSTALLATION
