mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

ABOUT US
Engine Roll Stopper and Center Member|Page 4599 > < Engine Roll Stopper and Center Member|Page 4597

Lancer L4-2.4L (4B12) (2009)

Page 5
background image

]]C[[ STEERING COLUMN SHAFT ASSEMBLY AND STEERING GEAR AND LINKAGE ASSEMBLY CONNECTION/STEERING
COLUMN BOLT INSTALLATION

1. Pinch the claw of the clip shown in the figure. While sliding shaft A from shaft B, connect the steering column shaft assembly with the steering

gear and linkage assembly.

2. Insert the steering column bolt into the non-threaded bolt hole, and tighten it to the specified torque.

Tightening torque: 20 ± 5 Nm (15 ± 3 ft-lb)

Engine Roll Stopper and Center Member|Page 4599 > < Engine Roll Stopper and Center Member|Page 4597