Lancer L4-2.4L SOHC (2005)
2. Turn the ignition switch to the "ON" position.
3. Measure the voltage between terminal 10 and ground.
-
The voltage should equal approximately 12 volts (battery positive voltage).
Q: Is the measured voltage approximately 12 volts (battery positive voltage)?
YES: Replace the power window main switch. Verify that the power windows work normally.
NO: Go to Step 13.
STEP 13. Check ETACS-ECU connector C-226 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is ETACS-ECU connector C-226 in good condition?
YES: Go to Step 14.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the power windows work normally.
