Lancer L4-2.4L SOHC (2005)
STEP 2. Check the transmission range switch.
Disconnect transmission range switch connector B-16. Then check continuity between the switch terminals.
Q: Is the transmission range switch in good condition?
YES: Go to Step 3.
NO: Replace the transmission range switch. If the rear wiper operates normally, it indicates that a correct "R" position signal is sent from the
transmission range switch.
STEP 3. Check the ignition switch (IG1) line of the power supply circuit to the park/neutral switch. Measure the voltage at park/neutral switch
connector B-16.
1. Disconnect transmission range switch connector B-16 and measure the voltage available at the wiring harness side of the connector.
2. Turn the ignition switch to the "ON" position.
3. Measure the voltage between terminal 8 and ground.
-
The voltage should equal approximately 12 volts (battery positive voltage).
Q: Is the measured voltage approximately 12 volts (battery positive voltage)?
YES: Go to Step 5.
NO: Go to Step 4.
