Lancer L4-2.4L SOHC (2005)
1. Disconnect ETACS-ECU connector C-226 and measure the voltage available at the junction block side of the connector.
2. Turn the ignition switch to the "ON" position.
3. Measure the voltage between terminal 8 and ground.
-
The voltage should equal approximately 12 volts (battery positive voltage).
Q: Is the measured voltage approximately 12 volts (battery positive voltage)?
YES: Go to Step 6.
NO: Go to Step 5.
STEP 5. Check the wiring harness between ETACS-ECU connector C-226 (terminal 8) and the ignition switch (IG1).
NOTE: Also check junction block connector C-211 for loose, corroded, or damaged terminals, or terminals pushed back in the connector. If junction
block connector C-211 is damaged, Repair or replace the damaged component(s) as described in Harness Connector Inspection.
