Lancer L4-2.4L SOHC (2005)
N05091 or greater.
c.If the database version is less than N05091, go to Step 5.
d.If the database version is N05091 or greater, go to Step 9.
5. Turn the ignition key to OFF and disconnect the MUT-III.
6. Install Reflash Update CD 10/05 in the MUT-III laptop. Follow the CD installation instructions.
7. Transfer the reprogramming data from the laptop to the memory card. (Use the port on the left side of the MUT-III laptop.) Select ECU
Reprogramming, then Memory Card Transfer. A status bar will display while the data is loading into the memory card.
8. When the memory card data transfer is complete, remove the memory card from the laptop and install it in the VCI. Connect the VCI to the
vehicle, using the RED CABLE. Be sure to connect both the 12-pin and 16-pin connectors securely. (On Outlander models, adapter harness
MB991855 is required.) YOU MUST DISCONNECT THE MUT-III LAPTOP.
9. Reprogram the PCM, using VCI automatic reprogramming. It will take up to 20 minutes to complete the reprogramming.
NOTE: If the message "ECU at Current Level of VCI" appears, the PCM did not reprogram. Verify that the ROM ID is the same as the ROM ID
listed in the table below.
- If the ROM ID is the same as or higher than the ROM ID in the table, the PCM has been reprogrammed for this concern.
- If it is not, verify that the correct database update is in the MUT-III and was transferred to the memory card, and that the memory card is properly
installed in the VCI.
CAUTION!
DO NOT DISTURB THE HARNESS CABLES OR CONNECTIONS. INTERRUPTION DURING THE PROGRAMMING PROCESS
COULD CAUSE THE PCM TO LOSE DATA OR PREVENT FUTURE PCM REPROGRAMMING.
a. After reprogramming is completed, the new ENG ROM ID and new A/T ROM ID will display alternately with the message "Turn IG SW OFF"
every four seconds. Note this information.
