Lancer LS L4-2.0L SOHC (2002)
2. Measure the resistance between the speed sensor terminals.
Standard value: 1.24 - 1.64 k Ohms
3. If the internal resistance of the speed sensor is not within the standard value, replace it with a new speed sensor.
4. Remove all connections from the speed sensor. The circuit should be open between terminals (1) and (2) and the body of the speed sensor. If the
circuit is not open, replace with a new speed sensor.
5. Check the speed sensor cable for breakage, damage or disconnection. Replace with a new one if a problem is found.
NOTE: When checking for cable damage, remove the cable clamp part from the body and then gently bend and pull the cable near the clamp.
TOOTHED ABS ROTOR CHECK
Check whether the ABS rotor teeth are broken or deformed. Replace the driveshaft assembly for the front side, or the ABS rotor for the rear side,
respectively, if the teeth are damaged or deformed.
