Lancer LS L4-2.0L SOHC (2002)
a.
After reprogramming is completed, the new ENG ROM ID and new A/T ROM ID will display alternately with the message "Turn IC SW
OFF" every four seconds. Note this information. Verify that the new PCM part number and ROM IDs are the same as those listed in the
table.
12.
If DTC P0421 was set in the PCM, replace the warm-up catalytic converter, using the exhaust manifold repair kit listed in the PARTS
INFORMATION section of this bulletin. Refer to Group 17 (for California emissions vehicles) or Group 15 (except California emissions vehicles)
in the appropriate service manual for installation instructions.
13.
Using a ball-point pen, enter the appropriate PCM part number, vendor number, ROM ID #, this recall bulletin number (EMR-05-001), your
dealer code, and the current date on the Engine Compartment / Control Module Label (p/n MSSF-024G-00).
14.
Carefully remove all dirt and oil from a vacant area near the VECI label on the underside of the hood, and affix the Engine Compartment label.
15.
Affix the Control Module label to the PCM.
16.
MODELS EQUIPPED WITH ABS: Reinstall the ABS fuse.
17.
FOR VEHICLES REGISTERED IN CALIFORNIA ONLY: Complete a "VEHICLE EMISSION RECALL - PROOF OF CORRECTION" form
(p/n MSSF-106D-00). Give the completed form to the vehicle owner.
NOTE:
These forms are available from Relizon at 1-866-980-7000.
PARTS INFORMATION
