Lancer LS L4-2.0L SOHC (2002)
10.
2002-2003 MODELS ONLY
If the vehicle has NOT already had the heater blend link and lever replaced as described in TSB-04-55-003:
Use the heater air blend link and lever kit listed in the PARTS INFORMATION section of this bulletin.
Apply a small amount of grease to the slot in the new door link, and to the gearteeth on the new lever.
Install the new link and lever to the heater box.
11.
Adjust the gear so that the raised dot on the gear is aligned with the notch in the blend door as shown.
IMPORTANT:
The raised dot on the gear for the door track must be aligned with the notch in the door lever to achieve proper timing. If the link and lever are not
installed properly, binding will result.
12.
Install the new seal provided in the heater blend door kit.
13.
Reassemble the case. Use all of the screws provided in the kit, as there may be one or more broken case tabs. Be sure that there are no gaps after
reassembly.
14.
Reinstall the heater case and expansion valve block. Reconnect the hoses and pipes. Reinstall the instrument panel.
15.
On vehicles that do not have a blower motor housing filter already installed as original equipment, install a blower motor housing filter as follows:
a.
Remove the glove box lid.
