Lancer LS L4-2.0L SOHC (2002)
1. Disconnect rear power window sub-switch (RH) connector E-17, and measure at the harness side.
2. Measure the resistance value between terminal 8 and ground.
-
The measured value should be 2 Ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 41.
NO: Go to Step 39.
STEP 39. Check power window main switch connector E-05 and rear power window sub-switch (RH) connector E-17
for damage.
Q: Are power window main switch connector E-05 and rear power window sub-switch (RH) connector E-17 in good condition?
YES: Go to Step 40.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. When the rear power window sub-switch (RH) is operated, the rear
power window (RH) should open or close normally.
