Lancer LS L4-2.0L SOHC (2002)
CAUTION: To prevent damage to scan tool MB991502, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991502. Also connect SWS monitor kit MB991862 after turning on scan tool MB991502.
1. Connect scan tool MB991502 to the data link connector.
2. Connect SWS monitor kit MB991862 to the column switch connector.
3. Select "WIPER - F. WIPER INT" (FUNCTION DIAG.), and check that normal conditions are displayed on the items described in the table.
NOTE: Also check that the windshield wiper interval changes smoothly when the windshield intermittent wiper interval adjusting knob is rotated
from "SLOW" to "FAST" positions.
Q: Does the value change within the normal range when the windshield intermittent wiper interval adjusting knob is rotated?
YES: Replace the front-ECU. Check that the windshield intermittent wiper interval changes according to the vehicle speed or while the
windshield intermittent wiper interval adjusting knob is rotated.
NO: Refer to Inspection Procedure L-7 "ETACS-ECU does not receive a signal from the windshield mist switch."
Inspection Procedure F-6
Windshield Wiper and Washer: The Windshield Intermittent Wiper Interval is not Changed According to the Vehicle Speed
Windshield Intermittent Wiper Circuit
NOTE: This troubleshooting requires use of scan tool MB991502 and SWS monitor kit MB991862. For details of how to use the SWS monitor, refer
to "How to use SWS monitor".
TECHNICAL DESCRIPTION (COMMENT)
If the windshield intermittent wiper interval is not changed according to the vehicle speed, the ETACS" ECU or the front-ECU may be defective.
TROUBLESHOOTING HINTS
-
Malfunction of the ETACS-ECU
-
Malfunction of the front-ECU
-
Damaged harness wires or connectors
