Lancer LS L4-2.0L SOHC (2002)
STEP 4. Check at rear washer motor connector A-23 to check the rear washer motor ground circuit
1. Disconnect rear washer motor connector A-23, and measure at the wiring harness side.
2. Measure the resistance value between terminal 1 and ground.
-
The measured value should be 2 Ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 7.
NO: Go to Step 5.
STEP 5. Check rear washer motor connector A-23 for damage.
Q: Is rear washer motor connector A-23 in good condition?
YES: Go to Step 6.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. Check that the rear washer works normally.
STEP 6. Check the wiring harness between rear washer motor connector A-23 and ground.
Q: Is the wiring harness between rear washer motor connector A-23 and ground in good condition?
YES: No action to be taken.
NO: Repair the wiring harness. Check that the rear washer works normally.
