Lancer LS L4-2.0L SOHC (2002)
STEP 17. Check the wiring harness between position light (RH) connector A-24 and front-ECU connector A-10X.
NOTE: Also check joint connector C-05 and intermediate connectors C-111 and C-129. If joint connector C-05, intermediate connector C-111 or
C-129 is damaged, repair or replace the connector as described in Harness Connector Inspection.
Q: Is the wiring harness between position light (RH) connector A-24 and front-ECU connector A-10X in good condition?
YES: No action to be taken.
NO: Repair the wiring harness. Check that the position light (RH) illuminates normally.
STEP 18. Check the stop/tail light bulb (LH).
1. Remove the stop/tail light bulb (LH).
2. Check that the stop/tail light bulb (LH) is not broken.
Q: Is the stop/tail light bulb (LH) in good condition?
YES: Go to Step 19.
NO: Replace the stop/tail light bulb (LH). Check that the tail lights (LH) illuminate normally.
STEP 19. Measure at rear combination light (LH) connector F-14 in order to check the ground circuit to the rear combination light (LH).
1. Disconnect rear combination light (LH) connector F-14, and measure at the wiring harness side.
2. Measure the resistance value between terminal 5 and ground.
-
The measured value should be 2 Ohm or less.
Q: Does the measured resistance value correspond with this range?
