Lancer LS L4-2.0L SOHC (2002)
front turn-signal light (RH): Go to Step 12.
side turn-signal light (LH): Go to Step 18.
side turn-signal light (RH): Go to Step 24.
rear combination light (LH): Go to Step 30.
rear combination light (RH): Go to Step 36.
combination meter (LH): Go to Step 42.
combination meter (RH): Go to Step 44.
Combination meter (both right and left): Go to Step 46
LH side only : Refer to Inspection Procedure L-1 "Turn-signal lights does not flash when the turn-signal light switch is turned on."
RH side only : Refer to Inspection Procedure L-1 "Turn-signal lights does not flash when the turn-signal light switch is turned on."
Both LH and RH sides : Refer to Inspection Procedure L-2 "Hazard warning light does not illuminate."
STEP 2. Check front turn-signal light (LH) connector A-16 and ETACS-ECU connector C-226 for damage.
Q: Are front turn-signal light (LH) connector A-16 and ETACS-ECU connector C-226 in good condition?
YES: Go to Step 3.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. Check that the turn-signal lights illuminate normally.
