Lancer LS L4-2.0L SOHC (2002)
STEP 13. Check the wiring harness between rear dome light connector D-07 and ETACS-ECU connector C-226.
NOTE: Also check junction block connector C-218. If junction block connector C-218 is damaged, repair or replace the connector as described in
Harness Connector Inspection.
Q: Is the wiring harness between rear dome light connector D-07 and ETACS-ECU connector C-226 in good condition?
YES: No action to be taken.
NO: Repair the wiring harness. Check that the rear dome lights illuminate normally.
STEP 14. Check the luggage compartment light bulb.
Q: Is the luggage compartment bulb in good condition?
YES: Go to Step 15
NO: Replace the bulb. Check that the luggage compartment lights illuminate normally.
STEP 15. Measure at luggage compartment light connector F-02 in order to check the ETACS-ECU line of the power supply to the luggage
compartment light.
1. Disconnect luggage compartment light connector F-02, and measure at the wiring harness side.
2. Measure the voltage between terminal 1 and ground.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES: Go to Step 18.
