Lancer LS L4-2.0L SOHC (2002)
Q: Is hazard warning light switch connector C-03 in good condition?
YES: Go to Step 4.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. If the equipment, which are described in "CIRCUIT OPERATION",
work normally, the input signal from the hazard warning light switch should be normal.
STEP 4. Check the wiring harness between hazard warning light switch connector C-03 and ground.
NOTE: Also check joint connector C-06. If joint connector C-06 is damaged, repair or replace the connector as described in Harness Connector
Inspection.
Q: Is the wiring harness between hazard warning light switch connector C-03 and ground in good condition?
YES: No action to be taken.
NO: Repair the wiring harness. If the equipment, which are described in "CIRCUIT OPERATION", work normally, the input signal from the hazard
warning light switch should be normal.
STEP 5. Check hazard warning light switch connector C-03 and ETACS-ECU connector C-228 for damage.
Q: Are hazard warning light switch connector C-03 and ETACS-ECU connector C-228 in good condition?
YES: Go to Step 6.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. If the equipment, which are described in "CIRCUIT OPERATION",
work normally, the input signal from the hazard warning light switch should be normal.
