Lancer LS L4-2.0L SOHC (2002)
c.
If the database version is less than N05111, go to Step 5.
d.
If the database version is N05111 or greater, go to Step 8.
5.
Turn the ignition key to OFF and disconnect the MUT-III.
6.
Gather the following reprogramming equipment:
-
MUT-III / STV Reflash Update CD 12105 or later
-
Memory Card 128 MByte Compact Flash MB991853
-
Memory Card Adapter PCMCIA MB991939
-
Engine Compartment/Control Module" Labels p/n MSSF-024G-00
7.
Install Reflash Update CD 12105 in the MUT-III laptop. Follow the CD installation instructions.
8.
Transfer the reprogramming data from the laptop to the memory card.
9.
Remove the memory card from the laptop and install it in the VCI. Connect the VCI to the vehicle. YOU MUST DISCONNECT THE MUT-III
LAPTOP.
10.
MODELS EQUIPPED WITH ABS: With the ignition key OFF, unplug the ABS fuse (7.5 amp fuse in junction box in passenger compartment).
11.
Reprogram the PCM, using automatic reprogramming. For reprogramming details, refer to TSB-03-00-015. It will take up to 20 minutes to
complete the reprogramming.
NOTE:
If the message "ECU at Current Level of VCI" appears, the PCM did not reprogram. Verify that the ROM ID is the same as the ROM ID listed in the
table.
^
If the ROM ID is the same as or higher than the ROM ID in the table, the PCM has been reprogrammed for this concern.
