Lancer LS L4-2.0L SOHC (2002)
WARNING: Battery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDLING.
2. Disconnect the negative (-) and positive (+) battery cables from the battery terminals, and then remove the battery from the vehicle.
WARNING: The side-airbag modules for both the driver's side and passenger's side should be deployed.
3. To deploy the side-airbag module: Remove the connection between the side-airbag module connector (red two-pin) and the side-airbag wiring
harness connector
NOTE: If the air bag module connector is disconnected from the body wiring harness, both electrodes of the air bag module connector will be
automatically shorted to prevent unintended deployment of the air bag due to static electricity, etc.
4. Connect deployment wires, each 6 meters (20 feet) or longer, to the two leads of special tool MB686560, and cover the connections with
insulation tape. The other ends of the deployment wires should be connected to each other (short-circuited), to prevent sudden unexpected
deployment of the air bag module.
5. Connect the side-airbag module two-pin connector to special tool MB686560 and move the deployment wires out of the vehicle.
WARNING: If the glass is scratched, air bag deployment could cause it to crack and fly out of the vehicle, so always put a cover over the
vehicle.
