Lancer LS L4-2.0L SOHC (2002)
[[F]] AIR BAG MODULE REMOVAL (FRONT PASSENGER'S SIDE)
WARNING:
-
When the passenger's air bag module is removed, do not damage the engagement of the pawls.
-
The removed passenger's air bag module should be stored in a clean, dry place with facing the deployment surface facing up.
Insert the screwdriver (-) into the position specified in the figure and lift the screwdriver upward to release the pawls engaged, and then remove the
passenger's air bag module.
INSTALLATION SERVICE POINTS
]]A[[ PRE-INSTALLATION INSPECTION
WARNING: Dispose of air bag modules only according to the specified procedure.
1. When installing the new air bag modules and clock spring, refer to "INSPECTION".
2. Connect the negative (-) battery cable.
CAUTION: To prevent damage to scan tool MB991502, always turn the ignition, switch to "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991502.
3. Connect scan tool MB991502 to the data link connector.
4. Turn the ignition switch to "ON" position.
5. Conduct diagnostic test using scan tool MB991502 to ensure entire SRS operates properly.
DANGER: Wait at least 60 seconds after disconnecting the battery cable before doing any further work.
WARNING: Battery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDLING.
6. Turn the ignition switch to the "LOCK" (OFF) position. Disconnect the negative (-) battery cable and tape the terminal to prevent accidental
connection and air bags deployment.
