Lancer LS L4-2.0L SOHC (2002)
-
MB628919 or MR203491: SRS Air Bag Adapter Harness C
-
MB686560: SRS Air Bag Adapter Harness B
-
MR372530: SRS Air Bag Adapter Harness A
WARNING:
-
If the vehicle is to be scrapped or otherwise disposed of, deploy the air bags and operate the seat belt pre-tensioner inside the vehicle. If
the vehicle will continue to be used and only the air bag modules and seat belt pre-tensioner are to be disposed of, deploy the air bags and
operate the seat belt pre-tensioner outside the vehicle.
-
Since a large amount of smoke is produced when the air bag is deployed and the seat belt pretensioner is operated, avoid residential areas
whenever possible.
-
Since there is loud noise when the air bags are deployed and when the seat belt pre-tensioner are operated, avoid residential areas
whenever possible. If anyone is nearby, give warning of the impending noise.
-
Suitable ear protection should be worn by personnel performing these procedures or by people in the immediate area.
DEPLOYMENT OUTSIDE THE VEHICLE
SEAT BELT PRETENSIONER
DANGER: Wait at least 60 seconds after disconnecting the battery cables before doing any further work.
WARNING:
-
Battery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDLING.
-
Operate the seat belt pre-tensioner in a wide, fiat area at least 6 meters (20 feet) away from obstacles and other people.
-
Do not perform operation outside if a strong wind is blowing. If there is a slight breeze, place the seat belt pre-tensioner downwind from
the battery.
1. Disconnect the negative (-) and positive (+) battery cables from the battery terminals, and then remove the battery from the vehicle.
WARNING: Store the operated seat belt pre-tensioner the correct way up with its operation surface upper most on a flat surface. Do not
place anything on top of them.
2. Remove the seat belt pre-tensioner from the vehicle.
3. Connect two wires, each 6 meters (20 feet) or longer, to the two leads of special tool MB686560, and cover the connections with insulation tape.
The other ends of the two wires should be connected to each other (short-circuited), to prevent sudden unexpected operation of the seat belt
pre-tensioner.
4. Connect the special tool MB686560, which the deployment wires is attached to, to the seat belt pre-tensioner connector.
CAUTION: The adapter harness below the wheel should be loose. If it is too tight, the reaction when the seat belt pre-tensioner operates could
damage the adapter harness.
5. Pass the thick wires through the hole on the seat belt pre-tensioner bracket and secure them to the front (raised part) of the wheel on two place.
