mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Seat Belt Buckle Switch > < Impact Sensor|Locations|Page 5477
Page 2
background image

[[A]] NEGATIVE (-) BATTERY CABLE DISCONNECTION

DANGER:  Wait at least 60 seconds after disconnecting the battery cable before doing any further work.

WARNING:  Battery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDLING

Disconnect the negative (-) battery cable from the battery and tape the terminal to prevent accidental connection and air bag deployment.

INSTALLATION SERVICE POINTS

]]A[[ PRE-INSTALLATION INSPECTION

Check the side impact sensor for dents, breakage and bending and measure the resistance between the terminals, even when installing a new side impact
sensor.

]]B[[ SIDE IMPACT SENSOR INSTALLATION

WARNING:  If the side impact sensor is not installed securely and correctly, the side-airbag may not operate normally. Securely connect the
connector

]]C[[ POST-INSTALLATION INSPECTION

1. Reconnect the negative (-) battery cable.
2. Turn the ignition switch to the "ON" position.
3. Does the "SRS" warning light illuminate for approximately seven seconds, go out?
4. If yes, the SRS system is functioning properly. If no, refer to SRS WARNING LIGHT CHECK.

Seat Belt Buckle Switch > < Impact Sensor|Locations|Page 5477