Lancer LS L4-2.0L SOHC (2002)
Use special tool MB990767 to fix the hub and remove the driveshaft nut
<<C>> TIE ROD END/LOWER ARM ASSEMBLY DISCONNECTION
CAUTION:
^
Do not remove the nut from ball joint. Loosen it and use special tool MB991113 or MB990635 to avoid possible damage to ball joint threads.
^
Hang special tool MB991113 or MB990635 with rope or wire to prevent them from falling.
Use special tool MB991113 or MB990635 to disconnect the tie rod end or lower arm assembly from the knuckle
<<D>> DRIVESHAFT REMOVAL
Use special tools MB990241 and MB990767 to pull out the driveshaft from the hub and knuckle.
INSTALLATION SERVICE POINT
>>A<< STABILIZER BAR INSTALLATION
Install the stabilizer bar so that the protruding length of the stabilizer bar mounting bolt meets its standard value (A)
Standard value (A): 22 ± 1.5 mm (0.87 ± 0.06 inch)
>>B<< DRIVESHAFT NUT INSTALLATION
1. Be sure to install the driveshaft washer in the specified direction.
