Lancer LS L4-2.0L SOHC (2002)
1. Remove the boot bands (large and small).
NOTE: The boot bands cannot be re-used.
2. Remove the R.J. boot.
3. Wrap a plastic tape around the shaft spline, and assemble the boot band and resin boot.
4. <For RJ boot>
Install the RJ boot with the part with the smallest diameter in a position such that the shaft groove can be seen.
<For BJ boot>
Align the center groove on the BJ boot small end with the shaft groove.
5. Turn the adjusting bolt on special tool MB991561 so that the size of the opening (W) is at the standard value.
Standard value (W): 2.9 mm (0.11 inch)
If it is larger than 2.9 mm (0.11 inch)>
Tighten the adjusting bolt.
If it is smaller than 2.9 mm (0.11 inch)>
Loosen the adjusting bolt.
NOTE: The value of W will change by approximately 0.7 mm for each turn of the adjusting bolt.
NOTE: The adjusting bolt should not be turned more than once.
