Lancer LS L4-2.0L SOHC (2002)
Follow the FLOWCHART shown. Observe the following points during repair:
1.
Replace the input shaft bearing if the rattle occurs both when the transaxle is cold and when it is at normal operating temperature.
a.
If the input shaft bearing is being replaced, inspect all bearings for wear. Carefully rotate each bearing and check for smooth rotation.
Replace any bearings that do not turn smoothly.
b.
EVOLUTION ONLY: Be sure to check the shaft clearances carefully, and adjust as necessary. Refer to Group 22 in the appropriate service
manual for clearance specifications.
2.
If the rattle occurs only at normal operating temperature:
a.
LANCER ONLY: Use the reverse idler gear kit (listed in the PARTS INFORMATION section of this bulletin) to replace the related parts.
If the noise continues after installing the reverse idle gear repair kit, replace the clutch disc.
NOTE:
Transmission removal is NOT necessary to remove the reverse idler gear.
b.
EVOLUTION ONLY: Replace the reverse idler gear components listed in the PARTS INFORMATION section of this bulletin. If the noise
continues after replacing the reverse idle gear components, replace the clutch disc.
PARTS INFORMATION
