Lancer LS L4-2.0L SOHC (2002)
4.
Remove the liner from the back of the felt pieces. Affix the felt on the inner clips as shown.
Affix one felt piece to each of the three inner clips.
Repeat on the other side.
5.
Be sure that the outer moulding clips (four on each side) are securely attached to the body retention stud as shown. If the clips are not properly
attached, noise may result.
6.
Reinstall the windshield side moulding.
7.
Test drive to verify the noise is eliminated.
PARTS INFORMATION
Use the Genuine Mitsubishi Part shown.
WARRANTY INFORMATION
