Engine Controls - MIL ON/DTC's P0300/P0301-P0304 Set: Page 21
Turn off the ignition switch and disconnect the MUT-III.
Turn off and disconnect the battery charger.
n. The CAN database screen will display.
Confirm the database number at the top right of the table is N10121 or higher.
If more than one row is displayed in the table refer to the ECM Reprogramming Chart, select the proper Data No. for this procedure and select the
appropriate row.
Click on the correct row to highlight it.
Click on the check mark to continue.
0. A message will ask you to "Check reprogramming data."
p. Click on the check mark to begin reprogramming.
It will take up to 5 minutes for reprogramming to complete.
CAUTION
THE DAYTIME RUNNING LIGHTS AND BOTH THE ENGINE AND CONDENSER FANS WILL AUTOMATICALLY BE TURNED ON
DURING PROGRAMMING. CARE SHOULD BE TAKEN TO INSURE NOTHING GETS CAUGHT IN THE MOVING BLADES. THE RADIO
WILL BE TURNED OFF AND YOU WILL ALSO HEAR A CHIME IN THE INTERIOR FOR A SHORT PERIOD OF TIME. THESE ARE
NORMAL CONDITIONS.