mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 5031 > < Initial Inspection and Diagnostic Overview|Page 5029
Page 7
background image

2. Measure the voltage between terminal 1 and ground.

OK: Battery positive voltage

Q: Is the measured voltage battery positive voltage?

YES : Go to Step 6.

NO : Go to Step 5.

STEP 5. Check the wiring harness between satellite radio tuner connector C-17 (terminal 1) and fusible link (36).

-

Check the power supply line for open circuit and short circuit.

NOTE:  Also check ETACS-ECU connectors C-307 and C-317 for loose, corroded, or damaged terminals, or terminals pushed back in the
connector. If ETACS-ECU connector C-307 or C-317 is damaged, repair or replace the connector.

Q: Is the wiring harness between satellite radio tuner connector C-17 (terminal 1) and fusible link (36) in good condition?

YES : No action is necessary and testing is complete.

NO : The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. The system should communicate with the satellite radio tuner normally.

STEP 6. Retest the system

Check if the satellite radio tuner works normally.

Q: Is the check result normal?

YES : The trouble can be an intermittent malfunction. (Refer to How to use Troubleshooting/inspection sevice points - How to cope with
Intermittent Malfunction).

NO : Replace the satellite radio tuner.

Inspection Procedure 3

Inspection Procedure 3: The error code "ANTENNA ERROR" is displayed on the display.

CAUTION:  Before replacing the satellite radio tuner, ensure that the power supply circuit and the ground circuit are normal.

TECHNICAL DESCRIPTION (COMMENT)

When there is a failure in the antenna base, antenna rod, or there is an open circuit or improper connection in the antenna feeder, and the satellite radio
tuner cannot receive normal voltage value or current value, the error code "ANTENNA ERROR" is displayed on the display.

TROUBLESHOOTING HINTS

-

Antenna rod may be defective

-

Antenna base may be defective

-

Antenna feeder may be defective

-

Satellite radio tuner may be defective

Initial Inspection and Diagnostic Overview|Page 5031 > < Initial Inspection and Diagnostic Overview|Page 5029