Lancer Sportback L4-2.4L (4B12) (2010)
/Page-1298008.png)
STEP 2. Check clock spring connector C-204 and C-205 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Are clock spring connector C-204 and C-205 in good condition?
YES : Go to Step 3.
NO : Repair or replace the damaged component. The steering remote control switch should work normally.
STEP 3. Check the clock spring.
Check whether the clock spring is in good condition (Refer to Driver's Air Bag Module and Clock Spring [EXCEPT RALLIART] See: Restraint
Systems/Air Bag Systems/Air Bag/Testing and Inspection/Driver's Air Bag Module and Clock Spring [GTS] or [RALLIART]).
Q: Is the check result normal?
YES : Go to Step 4.
NO : Replace the clock spring.
STEP 4. Check multivision display connector C-12 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is multivision display connector C-12 in good condition?
YES : Go to Step 5.
NO : Repair or replace the damaged component.
STEP 5. Check the wiring harness between multivision display connector C-12 (terminal 53, 69) and clock spring connector C-205 (terminal 2,
3).
-
Check the communication lines for open and short circuit.
NOTE: Also check intermediate connector C-105 for loose, corroded, or damaged terminals, or terminals pushed back in the connector. If
intermediate connector C-105 is damaged, repair or replace the connector.
Q: Is the wiring harness between multivision display connector C-12 (terminal 53, 69) and clock spring connector C-205 (terminal 2, 3) in good
condition?
YES : Go to Step 6.
NO : The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary.
STEP 6. Check steering wheel audio remote control switch connector C-202 for loose, corroded or damaged terminals, or terminals pushed
back in the connector.
Q: Is steering wheel audio remote control switch connector C-202 in good condition?
YES : Go to Step 7.
NO : Repair or replace the damaged component. The steering remote control switch should work normally.
STEP 7. Check the wiring harness between steering wheel audio remote control switch connector C-202 (terminal 2, 4) and clock spring
connector C-204 (terminal 5, 4).
-
Check the communication lines for open and short circuit.
Q: Is the wiring harness between steering wheel audio remote control switch connector C-202 (terminal 2, 4) and clock spring connector C-204
(terminal 5, 4) in good condition?
YES : Go to Step 8.
NO : The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary.
