Lancer Sportback L4-2.4L (4B12) (2010)
/Page-1358004.png)
1. Jack up and support the font axle crossmember, remove the front axle crossmember mounting bolt.
2. Check the hoses and harnesses for roughness, and then remove the front axle crossmember assembly with the rear roll stopper, steering gear and
linkage and stabilizer bar installed.
INSTALLATION SERVICE POINTS
[A] STABILIZER BAR/STABILIZER BUSHING/STABILIZER BAR BRACKET INSTALLATION
1. Install the stabilizer bar as shown in the figure.
2. Install the stabilizer bushing as shown in the figure.
[B] JOINT COVER GROMMET INSTALLATION
Install the joint cover grommet to the steering gear and linkage by aligning the mating marks as shown in the figure.
