Lancer Sportback L4-2.4L (4B12) (2010)
NOTE: Slide the foot to adjust the engine hanger balance.
2) Mount special tool MB991454 to the power steering oil pump bracket and the engine hanger, and set it to special tool MB991895 to support
the engine and transaxle assembly.
[D] TIMING CHAIN CASE ASSEMBLY REMOVAL
CAUTION
If the adhesive strength of sealant on the timing chain case assembly is so strong that the boss may be damaged by peeling off, do not peel it
off forcibly.
1. After removing the timing chain case assembly mounting bolts, slightly pry the boss of the timing chain case assembly shown in the figure using a
flat-tipped screwdriver, and remove the timing chain case assembly from the cylinder head and cylinder block.
2. If the sealant cannot be peeled off easily, insert a wooden hammer shank into the timing chain case assembly inside as shown in the figure, pry
slightly, and remove the timing chain case assembly from the cylinder head and cylinder block.
[E] TIMING CHAIN TENSIONER REMOVAL
1. Temporarily install the crankshaft pulley to the crankshaft.
CAUTION
Never turn the crankshaft counterclockwise.