Lancer Sportback L4-2.4L (4B12) (2010)
Idle Speed: Testing and Inspection
CURB IDLE SPEED CHECK
Required Special Tool:
MB991958: Scan Tool (M.U.T.-III Sub Assembly)
^
MB991824: V.C.I.
^
MB991827: M.U.T.-III USB Cable
^
MB991910: M.U.T.-III Main Harness A
1. Before inspection, set the vehicle in the following condition:
^
Engine coolant temperature: 80 - 95°C (176 - 203°F)
^
Lights and all accessories: OFF
^
Transaxle: Neutral (P range on vehicles with CVT)
NOTE: On vehicles for Canada, the headlight, taillight, etc. remain lit even when the lighting switch is in "OFF" position but this is no
problem for checks.
CAUTION
To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991958.
2. Connect scan tool MB991958 to the data link connector.
3. Set the timing light to the terminal No. 3 power supply line (white-red) of the ignition coil No. 1.
4. Start the engine.
5. Run the engine at idle for 2 minutes.
6. Check the actual ignition timing is at the standard value.
Standard value: Approximately 10° BTDC