Lancer Sportback L4-2.4L (4B12) (2010)
NO [Normal condition is not displayed for item No. 254.] : Troubleshoot the ETACS-ECU. Refer to Diagnosis - Inspection Procedure 2
"ETACS-ECU does not receive any signal from the ignition switch (IG1)". See: Body and Frame/Body Control Systems/Body Control
Module/Testing and Inspection/Scan Tool Testing and Procedures/Input Signal Procedures/Inspection Procedure 2
NO [Normal condition is not displayed for item No. 256.] : Troubleshoot the ETACS-ECU. Refer to Diagnosis - Inspection Procedure 6
"ETACS-ECU does not receive any signal from the front the front door switch (RH)". See: Body and Frame/Body Control Systems/Body Control
Module/Testing and Inspection/Scan Tool Testing and Procedures/Input Signal Procedures/Inspection Procedure 6
NO [Normal condition is not displayed for item No. 264.] : Troubleshoot the ETACS-ECU. Refer to Diagnosis - Inspection Procedure 3
"ETACS-ECU does not receive any signal from key reminder switch". See: Body and Frame/Body Control Systems/Body Control
Module/Testing and Inspection/Scan Tool Testing and Procedures/Input Signal Procedures/Inspection Procedure 3
NO [Normal condition is not displayed for item No. 270, 271.] : Troubleshoot the ETACS-ECU. Refer to Diagnosis - Inspection Procedure 4
"ETACS-ECU does not receive any signal from front door lock actuator". See: Body and Frame/Body Control Systems/Body Control
Module/Testing and Inspection/Scan Tool Testing and Procedures/Input Signal Procedures/Inspection Procedure 4
STEP 3. Check key reminder switch connector C-213, ETACS-ECU connector C-315 for loose, corroded or damaged terminals, or terminals
pushed back in the connector.
Q: Is key reminder switch connector C-213, ETACS-ECU connector C-315 in good condition?
YES : Go to Step 4.
NO : Repair the damaged parts.
STEP 4.Check the Wiring harness between key reminder switch connector C-213 (terminal No.5) and ETACS-ECU connector C-315 (terminal
No.18).
-
Check the input/output line for open circuit and short circuit.
Q: Is the check result normal?
YES : Go to Step 5.
NO : Repair the wiring harness between key reminder switch connector C-213 and ETACS-ECU connector C-315.
STEP 5. Check of ignition key cylinder illumination light bulb.
Q: Is the ignition key cylinder illumination light bulb in good condition?
YES : Go to Step 6.
NO : Replace the bulb of the ignition key cylinder illumination light.
STEP 6. Check the wiring harness between key reminder switch connector C-213 (terminal No.7) and body ground.
-
Check the ground line for open circuit.
Q: Is the check result normal?
YES : Go to Step 7.
NO : Repair the wiring harness between key reminder switch connector C-213 and body ground.
STEP 7. Retest the system.
Q: Does the ignition key cylinder illumination light illuminate/extinguish in good condition?
YES : The trouble can be an intermittent malfunction. (Refer to How to use Troubleshooting/inspection sevice points - How to cope with
Intermittent Malfunction).
NO : Replace the ETACS-ECU.
Inspection Procedure 2
INSPECTION PROCEDURE 2: DEFECTIVE POWER SUPPLY SYSTEM OF THE IGNITION SWITCH