Lancer Sportback L4-2.4L (4B12) (2010)
Pry the door beltline molding clip positions with the flat-tipped screwdriver and remove the door beltline molding.
[[B]] DOOR BELTLINE MOLDING [REAR DOOR] REMOVAL
1. Prize the clip of the door beltline molding using a flat-tipped screwdriver in the order of the numbers (from 1 to 4) shown in the figure. Lift the
vehicle front side of the door beltline molding.
NOTE: The flat-tipped screwdriver cannot be used at clips 5 and 6 of the door beltline molding shown in the figure.
2. Lift the door beltline molding in the direction of the arrow in the figure, then remove the door beltline molding.
[[C]] DOOR OPENING WEATHERSTRIP OUTER REMOVAL
Make the tool as shown in the figure, and remove the weatherstrip from the door panel.
INSTALLATION SERVICE POINTS
]]A[[ DOOR OPENING WEATHERSTRIP OUTER INSTALLATION