Mirage L4-1468cc 1.5L SOHC 12 Valve (1996)
Throttle Position Sensor: Adjustments
NOTE: When using scan tool, proceed to service data item 26 and observe the ON/OFF changes to the closed throttle position switch, instead of
performing ohmmeter tests. If scan tool not available, follow the steps below.
1. Disconnect the connector of the throttle position sensor.
2. Connect an ohmmeter between terminal No. 3 (closed throttle position switch) and No. 4 (sensor ground) by using jumper wires.
3. Insert a feeler gauge with a thickness of 0.65 mm (0.0256 in.) between the fixed SAS and the throttle lever.
4. Loosen the throttle position sensor mounting bolt; then turn the throttle position sensor body fully counterclockwise.
5. In this condition, check for continuity between terminals No. 3 and No, 4.
