Mirage L4-1597cc 1.6L DOHC (1990)
5. Using an ohm meter, check the resistance between the terminals.
Resistance
36 - 44 ohms @68° F
HARNESS TEST
1. Disconnect the solenoid connector and turn the key to the ON position.
2. Using a voltmeter, measure voltage between the harness connector terminal 2 and ground.
Voltage:
System voltage.
3. Turn the key to the OFF position and disconnect the ECU connector.
4. Using an ohmmeter, check for continuity between the ECU harness connector terminal 62 and the solenoid harness connector terminal 1.
Continuity:
Should exist.
5. Using an ohmmeter, check for continuity between the solenoid harness connector terminal 1 and ground.
Continuity:
Should not exist.
If any of the previous tests produce unsatisfactory results, the harness will need to be repaired or replaced. Once repairs have been completed, road
test the vehicle to confirm that the repair has corrected the problem.
If the same problem reoccurs, it is possible that there is an intermittent failure of the component or the ECU. Check for looseness at all harness
junctions and test for an intermittent failure.