Mirage L4-1597cc 1.6L DOHC (1990)
Drive out the spring pin from the control finger using a pin punch.
CAUTION: When removing the spring pin, turn the control lever to such position that the spring pin will not contact the clutch housing.
7. REMOVAL OF SPRING PIN
Drive out the spring pin from the stopper body using a pin punch.
CAUTION: When removing the spring pin, pull the control shaft in the direction illustrated so that the spring pin will not contact the clutch
housing.
SERVICE POINTS OF REASSEMBLY
17. 16.
INSTALLATION OF NEEDLE BEARINGS
Install the needle bearing flush with the surface A of the clutch housing.
15. INSTALLATION OF OIL SEAL
