Mirage L4-1597cc 1.6L DOHC (1990)
2. Set the washer on the back of each pinion and insert the two pinions to specified position while engaging them with the side gears and turning
them.
3. Insert the pinion shaft.
4. Measure the backlash between the side gears and pinions.
Standard value: 0.025 - 0.150 mm (0.001 - 0.006 in.)
5. If the backlash is out of specification, disassemble again and using correct spacer, reassemble and adjust.
CAUTION: Adjust for same backlash of both side gears.
5. INSTALLATION OF LOCK PIN
Align the pinion shaft lock pin hole with the case lock pin hole and insert the lock pin.
CAUTION:
1. Do not reuse the lock pin.
2. The lock pin must not protrude more than 3 mm (0.118 in.). <F5M21>
3. The lock pin head must be sunk from the flange surface of the differential case. <F5M22>
4. INSTALLATION OF TAPER ROLLER BEARING - F5M22