Mirage L4-1597cc 1.6L DOHC Turbo (1989)
1992-94 models:
TSB-93-35-003 advises that ABS ECU pin # 18 does not connect to ground but rather to a power source.
Notes:
1.
The pin numbers in the ECU connector may appear to be reversed. See Page 35B-20 in the 1996 Service Manual, Vol. 1 for more information.
2.
MUT-II can be used, but for 1991-94 models use the adapter harness supplied with the MUT-II tester.
3.
When the scan tool is connected, the ABS system does not function.
System Type: for FWD: Bosch 3 channel; for AWD: Nippon 2nd generation 2 channel
Diagnostic Page References:
1995 models: 1995 Eclipse Service Manual, Vol. 1. FWD: pages 35B-4 thru 35B-22. AWD: pages 35C-4 thru 35C-20. Circuit diagrams are in Vol. 2,
pages 187 thru 203.
1996 models: 1996 Eclipse Service manual, Vol. 1. FWD: pages 35B-4 thru 35B-22. AWD: Pages 35C-6 thru 35C-20. Circuit diagrams are in Vol. 2,
pages 220 thru 238.
Data Link Connector Location: Below instrument panel near center console. For both 1995 and 1996 models, see 1996 Service Manual, Vol. 1, page
5B-5 or Vol. 2, pages 237 and 238. (Refer to special scan tool instructions in this bulletin.)
Technical Service Bulletins:
1995 models:
TSB-95-35-004. Two pin numbers on the ECU are changed from the Service Manual, Vol. 2. Pin 8 in the circuit diagram should be Pin 31. Pin 14 in the
circuit diagram should be Pin 32.
Notes:
1.
Circuit diagrams for the Eclipse ABS are in Vol. 2, not Vol. 1.
2.
Diagnostics for FWD models and AWD models are in different sections of the Service Manual. Look in Section 35B for FWD diagnostics. Look
in Section 35C for AWD diagnostics.
3.
The pin numbers in the ECU connector may appear to be reversed. See Service Manual, Vol. 1, Page 35B-20 or 35B-24 or 35C-18 or 35C-21 for
more information.
4.
In the 1996 Eclipse, the ABS warning light is on when the scan tool is connected.
5.
No adapter harness is required for any 1995 Eclipse, even those with Chrysler power trains.
6.
Alternate method of erasing DTCs on FWD models only: turn ignition ON and pump the brake ten times to erase DTCs.
(Note that this is just the opposite of what you do with the 94-96 Galant Teves system, in which the same procedure causes the trouble codes to flash the
ABS light on the dash.)
Expo/Expo LRV 1992-95
System Type: for FWD: Nippon 2nd generation 3 channel; for AWD: Nippon 2nd generation 2 channel.
Diagnostic Page References:
1992-96 Expo/Expo LRV Service Manual, Vol. 1.
For 1992-94 models, FWD diagnostics are on Pages 35-11 thru 35-30; AWD diagnostics are on pages 35-31 thru 35-50.
Diagnostics for 1995 models are on pages 35-51 thru 35-70. Circuit diagrams and component locations are in Vol. 2, Pages 428453.
Data Link Connector Location: Driver side kick panel. See Service Manual page 35-41. (Refer to special scan tool instructions in this bulletin.)
