Mirage L4-1597cc 1.6L SOHC Turbo (1985)
Alignment: Service and Repair
Toe-In
Fig. 4 Toe setting
DESCRIPTION
As viewed from above, the wheels must be set so that distances A and B, Fig. 4, measured at wheel rims and at axle height, are different at a given
value. If distance A is smaller than distance B, the setting is known as toe-in. If distance A is greater than distance B, the setting is known as toe-out. The
toe setting is given in inches (mm) and refers to the difference between A and B. If distances A and B are the same, the toe setting is 0.
FRONT TOE-IN, ADJUST
1.
Adjust toe-in by undoing clips and turning left and right tie rod turnbuckles by same amount in opposite directions.
2.
To increase toe-out, turn left turnbuckle toward front of vehicle and right turnbuckle toward rear of vehicle. To increase toe-in, turn turnbuckles in
other direction. Toe-in is adjusted .24 in. on all except Mirage or .48 in. on Mirage for each half turn of left and right tie rods.
3.
After adjusting toe-in, check that steering wheel turning angle is within specifications.