Mirage L4-1795cc 1.8L SOHC 16 Valve (1995)
TRW (OMRON COPY) RKE (Factory-installed - See Group 42 in service manual)
System Operation: This is the U.S.-sourced version of the OMRON RKE system. It operates the same as the OMRON RKE and is 'hard-wired" into the
vehicle. Refer to the appropriate service manual for specific electrical connections. The receiver module is located near the rear speaker on the left side.
Transmitter Programming:
1. With the ignition key oft, connect the MUT-II scan tool into the data link connector.
2. Close all doors and the trunk (or hatch).
3. Turn the ignition key to "ACC" then to "OFF." The power door locks should cycle, indicating that you are in "Program" mode.
4. Press either button on the first transmitter slowly three times within ten seconds. The power door locks should cycle after the first transmitter is
programmed.
5. Press either button on the second transmitter slowly three times within ten seconds. The power door locks should cycle after the second transmitter
is programmed.
6. Disconnect the MUT-II and remove the ignition key.
7. Verify that both transmitters operate properly.
TRW RKE (Port/Dealer installed - Not included in service manual) System Operation:
Push the LOCK button to lock all doors. Push the UNLOCK button to unlock all doors. Does not operate the dome light. If equipped with the factory
alarm system, locking/unlocking the doors will arm/disarm the alarm system.
Receiver Module Location:
a. Diamante - Near glove box
b. Eclipse and Montero - Behind knee bolster on driver's side
c. Galant - On blower motor, above glove box
Electrical Connections: Spliced into central door locking system harness
a. Diamante and Galant - Above glove box
b. Eclipse and Montero - Interior relay box
Transmitter Programming:
