Mirage L4-1795cc 1.8L SOHC 16 Valve (1995)
1.
Open the driver's door.
2.
Turn the ignition key to the "ON" position.
3.
Press and hold the status indicator LED button (serves as the programming button). After about 15 seconds, the doors should lock and unlock three
times to indicate that you are now in programming mode. Continue holding the LED button.
4.
Press the "1" button on the first transmitter. The doors should lock and unlock.
5.
Press the "1" button on the second transmitter. The doors should lock and unlock.
6.
Release the programming button.
7.
Turn the ignition key to the "OFF" position and close the doors.
8.
Verify that both transmitters operate properly.
If the transmitters do not operate properly, use the following alternative method:
1.
Enter the vehicle and shut all doors.
IMPORTANT:
Steps 2 through 5 must all be performed within 10 seconds in order for the system to enter the programming mode.
2.
Turn the ignition key to the "ON" position.
3.
Using either the driver's door button or the dome light switch, turn the dome light on and oft three times.
4.
Turn the ignition key to the "OFF" position. The door locks should lock and unlock three times to indicate that you are in the programming mode.
5.
Press the "1" button on the first transmitter. The door locks should lock and unlock again.
6.
Press the "1" button on the second transmitter. The door locks should lock and unlock again.
7.
Turn the ignition key to the "ON" position, then to the "OFF" position.
8.
Verify that both transmitters operate properly.
CODEALARM RKE WITH SECURITY SYSTEM (1997-99 models) (Port/Dealer installed - Not included in service manual)
System Operation:
Operates the same as the CodeAlarm RKE Only system, except also provides siren, alarm, shock sensor and "panic" features. The status indicator light is
also used as the alarm override button. Can be installed on vehicles without power door locks to function as just an alarm system.
When the system is armed, unlocking a door with the key will activate the alarm. To disarm the system in this condition, press the "UNLOCK" button or
simultaneously press the status indicator light and turn the ignition key and start the engine.
^
Arming: Press the LOCK button to arm the alarm and lock all doors. The parking lights will blink and the siren will chirp. When the system
completes arming, the parking lights blink again and the siren chirps again. A status indicator light will begin blinking.
^
Activating: If the alarm is armed, it is activated by either opening a door or by the shock sensor. The siren sounds and the parking lights flash. After a
few minutes, the alarm deactivates and automatically re-arms itself. If the alarm has been activated, the status indicator light may blink faster.
