Mirage Sedan DE L4-1468cc 1.5L SOHC MFI (1997)
Throttle Full Close Switch: Adjustments
When not using the scan tool, proceed as follows:
1. Connect the scan tool to the data link connector.
(1) Disconnect the connector of the throttle position sensor.
(2) Connect an ohmmeter between terminal 3 (closed throttle position switch) and 4 (sensor ground) by using jumper wires.
2. Insert a feeler gauge with a thickness of 0.45 mm (0.177 in.) between the fixed SAS and the throttle lever.
3. When using the scan tool, turn the ignition switch ON. (Do not start engine.) Observe operation of the closed throttle position switch.
4. Loosen the throttle position sensor mounting bolt; then turn the throttle position sensor body fully counter clockwise.
5. In this condition, make sure that the closed throttle position switch is ON.
6. Slowly turn the throttle position sensor clockwise until the point at which the closed throttle position switch is turned OFF is found.
Tighten the throttle position sensor installation bolt at that position.
NOTE: The throttle position sensor should be checked after the above repairs are performed.
