Mirage Sedan DE L4-1468cc 1.5L SOHC MFI (1997)
Oxygen Sensor: Testing and Inspection
Federal
Federal Vehicles
1. Disconnect the heated oxygen sensor connector.
2. Make sure that there is continuity [7-40 Ohm at 20°C (68°F)] between terminal 3 and terminal 4 on the heated oxygen sensor connector.
3. If there is no continuity, replace the heated oxygen sensor.
NOTE:
1. If the scan tool does not display the standard value although no abnormality is found by the above mentioned continuity test and harness check,
replace the heated oxygen sensor (rear).