Mirage Sedan LS L4-1834cc 1.8L SOHC MFI (1999)
1. Set the special tool in the master cylinder.
2. Set the special tool shaft to a position where it lightly contacts the master cylinder piston.
3. Turn the wing bolt to fix the shaft.
4. Using a hand vacuum pump, apply a vacuum of -66.7 kPa (19.6 inch Hg) to the brake booster.
5. Reverse the special tool to shift it from the center of the brake booster.
6. Slide the special tool toward the center, and confirm that the protrusion of the shaft contacts the end of the brake booster push rod as shown in
drawing A. If the state is as shown in drawings B and C, adjust the push rod length with the following steps to achieve the state shown in A.
B: If a section other than the shaft protrusion is contacted, shorten the push rod.
C: If there is no contact with the shaft, extend the push rod.
